Network OS MIB Reference

Network OS 2.1.1

53-1002490-01

documentation@brocade.com

sFlow MIB

The MIB module for managing the generation and transportation of sFlow data records.

 

Object and OID	Access	Description
sFlowVersion 1.3.6.1.4.1.4300.1.1.1	Read-only	Uniquely identifies the version and implementation of this MIB.
sFlowAgentAddressType 1.3.6.1.4.1.4300.1.1.2	Read-only	The address type of the address associated with this agent. Only IPv4 and IPv6 address types are supported.
sFlowAgentAddress 1.3.6.1.4.1.4300.1.1.3	Read-only	The IP address associated with this agent.
sFlowTable 1.3.6.1.4.1.4300.1.1.4	Not accessible	A table of the sFlow samplers within a device.
sFlowEntry 1.3.6.1.4.1.4300.1.1.4.1	Not accessible	The attributes of an sFlow sampler.
sFlowDataSource 1.3.6.1.4.1.4300.1.1.4.1.1	Read-only	Identifies the source of the data for the sFlow sampler.
sFlowOwner 1.3.6.1.4.1.4300.1.1.4.1.2	Read-write	The entity making use of this sFlow sampler.
sFlowTimeout 1.3.6.1.4.1.4300.1.1.4.1.3	Read-write	The time (in seconds) remaining before the sampler is released and stops sampling.
sFlowPacketSamplingRate 1.3.6.1.4.1.4300.1.1.4.1.4	Read-write	The statistical sampling rate for packet sampling from this source.
sFlowCounterSamplingInterval 1.3.6.1.4.1.4300.1.1.4.1.5	Read-write	The maximum number of seconds between successive samples of the counters associated with this data source. A sampling interval of 0 disables counter sampling.
sFlowMaximumHeaderSize 1.3.6.1.4.1.4300.1.1.4.1.6	Read-write	The maximum number of bytes that must be copied from a sampled packet. The agent may have internal maximum and minimum permissible sizes. If an attempt is made to set this value outside the permissible range, then the agent must adjust the value to the closest permissible value.
sFlowMaximumDatagramSize 1.3.6.1.4.1.4300.1.1.4.1.7	Read-write	The maximum number of data bytes that can be sent in a single sample datagram. The manager must set this value to avoid fragmentation of the sFlow datagrams.
sFlowCollectorAddressType 1.3.6.1.4.1.4300.1.1.4.1.8	Read-write	The type of sFlow collector address.
sFlowCollectorAddress 1.3.6.1.4.1.4300.1.1.4.1.9	Read-write	The IP address of the sFlow collector. If the address is set to 0.0.0.0, all sampling is disabled.
sFlowCollectorPort 1.3.6.1.4.1.4300.1.1.4.1.10	Read-write	The destination port for sFlow datagrams.
sFlowDatagramVersion 1.3.6.1.4.1.4300.1.1.4.1.11	Read-write	The version of the sFlow datagrams that must be sent. When set to a value not supported by the agent, the agent must adjust the value to the highest supported value less than the requested value, or return an error if no such value exists.