Setting a static IP address

  1. Log into the switch using the default password, which is password.
  2. Use the ipaddrset command to set the Ethernet IP address.

    If you are going to use an IPv4 IP address, enter the IP address in dotted decimal notation as prompted.

    Ethernet IP Address: [192.168.74.102]
    

    If you are going to use an IPv6 address, enter the network information in colon-separated notation as prompted.

    switch:admin> ipaddrset -ipv6 --add 1080::8:800:200C:417A/64
    IP address is being changed...Done.
  3. Complete the rest of the network information as prompted. (IPv4 format shown)
    Ethernet Subnetmask: [255.255.255.0]
    Ethernet IP Address: [192.168.74.102]
    Ethernet Subnetmask: [255.255.255.0]
    
  4. Enter off to Disable DHCP when prompted.
    DHCP [OFF]: off