This Extension Switch might have more than one power cord. To reduce the risk of electric shock, disconnect both power cords before servicing.
Remove both power cords before servicing.
Disconnect the power cord from all power sources to completely remove power from the device.
Before plugging a cable into any port, be sure to discharge the voltage stored on the cable by touching the electrical contacts to ground surface.
Connect the power cord only to a grounded outlet.
Make sure that the power source circuits are properly grounded, then use the power cord supplied with the device to connect it to the power source.
This product is designed for an IT power system with phase-to-phase voltage of 230V. After operation of the protective device, the equipment is still under voltage if it is connected to an IT power system.