Network OS Administration Guide

Supporting Network OS 6.0.1a

Part Number: 53-1003768-04

Enabling/disabling standby MM console input

Use the key sequences shown in this section to either allow or prevent user console input.

By default, the standby MM console does not accept any key inputs. Using a special key sequence, you can enable /disable key-access input on the standby MM after HA synchronization is established.

Use the following keyboard sequences to disable and enable console user input:

  • To enable input: ctrl _ 1 (ctrl underscore and 1)
  • To disable input: ctrl _ 0 (ctrl underscore and 0)

Situations in which console user input becomes enabled are:

  • Whenever an MM becomes active due to cold start or warm start.
  • If the HA is out of sync for any reason.