Network OS Administration Guide

Supporting Network OS 6.0.1a

Part Number: 53-1003768-04

Viewing Fibre Channel port attributes

To view the Fibre Channel port attributes for a single port, in privileged EXEC mode, enter the show running-config interface FibreChannel rbridge-id/slot/port command for the port you want to view. To view the Fibre Channel port attributes for all Fibre Channel ports in the fabric, enter the show running-config interface FibreChannel command without any additional parameters.

Whether you view attributes for a single port or for all ports, the settings for the isl-r_rdy, trunk-enable, and shutdown attributes are always displayed. The fec-enable and speed attributes are displayed only if they are set to nondefault values.

The following example displays the Fibre Channel port attributes for a single port. In this case, the speed and vc-link-init attributes appear because they have been set to values other than their default values.

switch# show running-config interface FibreChannel 8/0/1
interface FibreChannel 8/0/1
 speed 8gbps 
 no isl-r_rdy
 trunk-enable
 shutdown

The following example shows Fibre Channel attributes for all Fibre Channel ports. In this case, the speed and fec-enable attributes are set to their default values for all of the interfaces shown.

switch# show running-config interface FibreChannel
interface FibreChannel 3/0/1
 desire-distance 0
 no isl-r_rdy
 trunk-enable
 no shutdown
!
interface FibreChannel 3/0/2
 no isl-r_rdy
 trunk-enable
 no shutdown
!
interface FibreChannel 3/0/3
 no isl-r_rdy
 trunk-enable
 no shutdown
!
      (output truncated)

To view the setting of a single attribute on a specific port, regardless of whether the attribute is set to its default value, enter the show running-config interface FibreChannel rbridge-id/slot/port command.

The following example shows the setting of the speed attribute for port 66/0/1:

switch# show running-config interface FibreChannel 66/0/1 speed interface FibreChannel 66/0/1
 speed 16gbps