Network OS Administration Guide

Supporting Network OS 6.0.1a

Part Number: 53-1003768-04

Restoring a configuration from backup

When you restore a configuration from backup and add to the running configuration, the zone configuration identified in the backup copy as the enabled configuration becomes the new enabled configuration.

In privileged EXEC mode, enter the copy command. For the source file use the file where the saved configuration is stored. For the destination file, use running-config.

This operation updates the defined configuration in RAM.

NOTE
The copy command adds to the defined configuration. It does not replace the defined configuration.

The following example adds the configuration in the file named myconfig on the attached USB device to the defined configuration.

switch# copy usb://myconfig running-config