Network OS Administration Guide

Supporting Network OS 6.0.1a

Part Number: 53-1003768-04

Setting and displaying the chassis name

  1. In privileged EXEC mode, issue the configure terminal command to enter global configuration mode.
  2. Enter the switch-attributes command, followed by a question mark (?) to determine the local RBridge ID.
  3. Enter the switch-attributes command, followed by the RBridge ID.
  4. Enter the chassis-name operand, followed by the chassis name.
  5. Save the configuration changes using the do copy running-config startup-config command.
    NOTE
    This step is used for switches in fabric cluster mode only. If you are using logical chassis cluster mode, startup configurations are not maintained by the cluster; each node preserves its running configuration. For more information about logical chassis cluster mode, refer to Logical chassis cluster mode.
    switch# configure terminal
    Entering configuration mode terminal
    switch(config)# switch-attributes ?
    Possible completions: <NUMBER:1-239> Specify the rbridge-id 1
    switch(config)# switch-attributes 1
    switch(config-switch-attributes-1# chassis-name lab1_vdx0023
    switch(config)# do copy running-config startup-config
    switch(config)# do show running-config switch-attributes 1
    switch-attributes 1
     chassis-name lab1_vdx0023
     host-name lab1_vdx0023