Network OS Administration Guide

Supporting Network OS 6.0.1a

Part Number: 53-1003768-04

Removing a member from an alias

  1. In privileged EXEC mode, enter the show running-config zoning command to display the alias and its member WWNs.
  2. Enter the configure terminal command to enter global configuration mode.
  3. Enter the zoning defined-configuration alias command followed the name of an existing zone alias.

    A subconfiguration mode prompt appears.

  4. Enter the subconfiguration mode no member-entry command to specify the WWN to be removed from the zone alias.

    You can only remove one member at a time.

  5. Enter the exit command to return to the global configuration mode.
  6. Enter the zoning enabled-configuration cfg-action cfg-save command to save the configuration to nonvolatile memory.

    The following provides an example of removing two members from an alias:

    switch# show running-config zoning
    zoning defined-configuration alias alias1
     member-entry 10:00:00:00:00:00:00:01
     member-entry 10:00:00:00:00:00:00:02
     member-entry 10:00:00:00:00:00:00:03
          (output truncated)
    switch# configure terminal
    Entering configuration mode terminal
    switch(config)# zoning defined-configuration alias alias1
    switch(config-alias-alias1)# no member-entry 10:00:00:00:00:00:00:02
    switch(config-alias-alias1)# no member-entry 10:00:00:00:00:00:00:03
    switch(config-alias-alias1)# exit
    switch(config)# zoning enabled-configuration cfg-action cfg-save