Network OS Administration Guide

Supporting Network OS 6.0.1a

Part Number: 53-1003768-04

Enabling a Fibre Channel port

  1. In privileged EXEC mode, enter the configure terminal command to enter global configuration mode.
  2. Enter the interface FibreChannel rbridge-id/slot/port command for the Fibre Channel port you want to enable.
    NOTE
    You do not to be in RBridge ID configuration mode to disable or enable a Fibre Channel port. It is recommended that you configure this on the principal switch.

    A configuration submode prompt appears.

  3. Enter the no shutdown command.

    The following example enables port 1 in slot 0 of RBridge ID 8.

    switch# configure terminal
    
    Entering configuration mode terminal
    switch(config)# interface FibreChannel 8/0/1
    switch(config-if-fi-8/0/1)# no shutdown