Network OS Administration Guide

Supporting Network OS 6.0.1a

Part Number: 53-1003768-04

Examples of global and local configurations

The following table provides examples of global and local configuration commands that are available under the respective configuration modes. These settings can be viewed respectively by means of the show global-running-config command and the show local-running-config command.

Table 6 Global and local configuration commands

Global

Local

Interface vlan

switch-attributes

interface port-channel

interface management

port-profile

interface ve

mac access-list

diag post

ip access-list

dpod

sflow

switch-attributes

snmp-server

fabric route mcast

protocol lldp

rbridge-id

zoning

ip route

cee-map

linecard

username

router ospf

ipv6 router ospf

router bgp

protocol vrrp

vrrp-group

interface management

interface gigabitethernet

interface tengigabitethernet

interface fortygigabitethernet

interface fcoe

Use the copy snapshot commands if you need to upload or download configuration snapshot files to and from an ftp or scp server. You may need to use these commands if you took a snapshot of a configuration on a node that was disconnected from the cluster.

Refer to the Network OS Command Reference for detailed information about these and other logical chassis server commands.